hey yall. i just bouht a Connex 3300HP and installed it. the Antenna is a 102'' Whip. but when i want to rx all i hear is static. nothing but static. idk wether its tha coax, the radio itself, or the power cord. any suggestions?
Connex 3300HP Problem
Discussion in 'CB Radio Forum' started by ptb379, Apr 16, 2010.
Page 1 of 2
-
-
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
-
Is it set like this (the bands DA/AM HI)? Just a FYI, you should run a 5A fuse for it.
-
Did you check to see the internal speaker isn't disabled.
-
I'm trying to install one, on a 4x4
Which type of cables did you get to connect to the battery?
Radio shat doesn't have much, and end up getting the wrong kind. -
-
Nope it On FM
-
Its Exactly Like That Radio. Even Down To The Faceplate!
-
When you get it right mark it with a sharpie... -
Thanks Big Rigger I Will Be Putting a 5 Amp Fuse in It Tomorrow
-
They tend to get hot if you get long winded on it. The only settings you need to worry about are D/A and AM and the band setting on HIGH. Everything else is optional. I mostly ran it on the low output setting unless I was in the boonies.
Also you need to set the SWR on this as well, if that hasn't been done already. If you can't figure out what the problem is with it, try to find a cb shop somewhere around you, they're usually reasonably priced and can get it right for you if they're any good.
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
Page 1 of 2