Ok I played some more. The ground was being fickle, I made some adjustments and got that to work. I still get the Antenna Warning thing going on, and when I did the system test function it says the Antenna fails. All of my testing this time around was with the Wilson 2000. I was not able to hear anyone on any channel, but switching over to Weather Band I was able to hear the weather report.
Any ideas??
Thank you
I need some help - Antenna Warning on SWR Check
Discussion in 'CB Radio Forum' started by HD_Renegade, Jun 15, 2011.
Page 2 of 9
-
-
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
-
get the wilson off the finder and buy u a mag mount and put it on the roof of the car/truck
rabbiporkchop Thanks this. -
You need to trim your antenna.
Switch to the swr function and tell us what you are reading on 1 and 40. -
Sounds like a problem I had a few years ago. Turned out to be the mic. Replaced it and the problem went away. Those cobra factory mics are junk. I'm not saying this is your problem but it is a possibility.
-
Try this one on for size. Previous owner of KW W900 installed CB into top portion over the dash. Looks impressive but doesn't work so now I am not so impressed. Tried to get it out and after careful examination it appears the only method for removing this beautiful piece of "artwork" is to disassemble the entire upper panel. Can't get to any plugs to see if any connections are loose or unplugged. All I can do is just idly stare at it and pretend somebody might be able to recognize the artist and name of the piece and offer me a small fortune for it one day. Or maybe I will hit one of those "smooth" roads we travel on and the danged thing will just jar itself out of there.
-
Interesting witht he 29 LX it has a knob on the front to adjust the SWR, I have it adjusted to right around 1.5 at the highest level. I am not sure if this is normal to be able to adjust the SWR this way or if you have to adjust it with moving that antenna? I am open for ideas on this.
Thank you -
You put the radio on calibrate, turn the SWR knob until the needle is close to the far right side of the meter. (there is a small square were the needle should point) then you switch to SWR and key up the mic on channel 1 and write down the reading, switch to 20 and key the mic and write down the reading, then switch to channel 40 and write down the reading. Come back here and tell us what the readings are on 1, 20 and 40.
Oh and read the manual that came with the radio. It will tell you exactally how to check the SWR. -
Folks I am still trying to figure this out, and I know I was asked for the SWR readings and I will get there and post it too.
Someone said something about maybe trying another MIC, does someone have one to recommend that I can get at the Local Truck Stop???
Thank you -
-
If I could find someone local to look at this it would be a lot eaiser for me. I have been trying to use google and the yellow pages to find someone, but no luck yet.
Thank you
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
Page 2 of 9