1.7 is fine but i would be going crazy until i got it to at least 1.3 as there is a difference might be small but its there i also ran a monkeymade and had mine at 1.2 across all channels for your cascadia get the one with the longest shaft as you want the coil as high as possible.
predator 10 k antenna /freightliner cascadia
Discussion in 'CB Radio Forum' started by stacks, Jul 21, 2014.
Page 2 of 9
-
-
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
-
I have the 22 inch shaft I've been trying to find a cb shop that sells just the 24 or 27 inch shaft for the predator but I may have to order it online cause the shops usually want to sell me an entire antenna
-
I have a wilson 2000 with the 2 bolt bird perch mount. It only has a 5 inch shaft and the swr's are running 1.8. Would going to a 10 inch shaft be better or should I just get a 5 foot fiberglass antenna?
-
-
Yes a cascadia, but I don't seem to get very good range with it. I have a uniden 880,. I was just wondering if a fiberglass antenna would serve better with this application. Also the swr meter I have is an old workman and not sure how accurate it is.
-
You really need more than 10" of shaft. The long-shaft, open-coil antennas are best for these trucks. Fiberglass will show a decent SWR but is simply not as good as having bare metal in the air.
My 5.5' Francis also showed a 1.3 SWR. Despite the SWR being the same once I got my Monkey-Made tuned down, range improved significantly.Last edited: Aug 2, 2014
-
-
102 is cheaper and better, but a little bit more difficult to mount. I have seen Cascadias with them, though.
-
This might help.
http://www.thetruckersreport.com/tr...-forum/249124-cascadia-antenna-solutions.htmlOzgur Thanks this. -
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
Page 2 of 9