Getting active fault 2010 Cascadia/DD15.
fault code is: ENG Oil Pressure
Sht Hi 128 100 03. Also oil pressure gage is at 0 but oil is still pumping through engine.
Any help would be appreciated to help isolate my problem.
active fault code? 2010 Cascadia/DD15
Discussion in 'Freightliner Forum' started by abenaki, Jan 22, 2014.
-
-
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
-
Possibly a faulty oil pressure sensor as it feeds info to the pressure gauge ( 0 PSI ) as well as the ECM ( ACTIVE FAULT ) or the oil pump has failed / clogged and unable to pump proper pressures.
abenaki Thanks this. -
Thanks for your reply. I hope it's just the sensor. Not sure where it is.
-
check wiring to MCM unit
-
Check it with a manual gauge.. There has been a few issues with the pick up tube o rings. I wouldnt assume that oil pressure is ok
abenaki Thanks this. -
Thanks all for your suggestions. It was the oil pressure sensor. A $31.93 part. Not bad. Again, Thanks.
FLATBED Thanks this.
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.