Freightliner Fault Codes

Discussion in 'Freightliner Forum' started by timtrucker1, Dec 18, 2014.

  1. timtrucker1

    timtrucker1 Bobtail Member

    13
    3
    May 13, 2013
    0
    Hey Guys and Gals,
    I have these codes on the dash
    ENG0
    CABB33
    CHS71
    EEC61

    I drive a 2012 Cascadia.... 420,000 miles
    What do each of these codes mean?
    Thanks
     
  2. Truckers Report Jobs

    Trucking Jobs in 30 seconds

    Every month 400 people find a job with the help of TruckersReport.

  3. FLATBED

    FLATBED Road Train Member

    Likely get a lot of response if it was posted in the GARAGE section and not under REPORT A BAD TRUCKING COMPANY
     
    Mattnatti and Lonesome Thank this.
  4. snowlauncher

    snowlauncher Road Train Member

    1,128
    2,286
    Mar 28, 2014
    Southeastern ID
    0
    I'm not a mechanic and don't pretend to be one, but from personal experience driving both a '12 and a '13 Cascadia, I had a few intermittent code faults. I notified my shop and was told that Cascadias do that from time to time. After a few times shutting the engine off and starting again they would clear. As long as the gauges were reading good and nothing on the motor was loose, leaking, or missing, I was told not to worry about it...IDK.
     
  5. Chip S

    Chip S Light Load Member

    200
    104
    May 27, 2013
    Texas
    0
    You are missing numbers for your fault codes. The numbers you are posting are just the source address for your different ecu's in the truck.
    eng0 is either ecm (cummmins) or mcm (detroit)
    cab33 is a fault in your sam cab
    chs71 is a fault in your sam chassis
    eec61 is a fault in your aftertreatment control module
     
    cab29 Thanks this.
  6. timtrucker1

    timtrucker1 Bobtail Member

    13
    3
    May 13, 2013
    0
  7. timtrucker1

    timtrucker1 Bobtail Member

    13
    3
    May 13, 2013
    0
    Ok... I guess I wont worry about it either.....Thanks
     
  8. timtrucker1

    timtrucker1 Bobtail Member

    13
    3
    May 13, 2013
    0
  9. Chip S

    Chip S Light Load Member

    200
    104
    May 27, 2013
    Texas
    0
    You may want to get your eec61 code checked. If you have a def problem, you could run into a severe engine derate
     
  10. tj9281

    tj9281 Bobtail Member

    14
    2
    Jan 19, 2015
    0
    The chassis code is usually a light somewhere. Not always, but thats what it usually is. Ive been told it can go off if a trailer light is bad as well, doesnt make a whole lotta sense, but i guess its possible.
     
  11. mhyn

    mhyn Road Train Member

    4,255
    4,502
    Dec 29, 2008
    Northridge, CA
    0
    each of this codes must have sub codes. write them and I will tell you exact problems. I have the code chart for 2012 Cascadia and if you are o/o I can share it.
     
    1fixitman Thanks this.
  • Truckers Report Jobs

    Trucking Jobs in 30 seconds

    Every month 400 people find a job with the help of TruckersReport.