Hey Guys and Gals,
I have these codes on the dash
ENG0
CABB33
CHS71
EEC61
I drive a 2012 Cascadia.... 420,000 miles
What do each of these codes mean?
Thanks
Freightliner Fault Codes
Discussion in 'Freightliner Forum' started by timtrucker1, Dec 18, 2014.
Page 1 of 2
-
-
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
-
Likely get a lot of response if it was posted in the GARAGE section and not under REPORT A BAD TRUCKING COMPANY
-
-
You are missing numbers for your fault codes. The numbers you are posting are just the source address for your different ecu's in the truck.
eng0 is either ecm (cummmins) or mcm (detroit)
cab33 is a fault in your sam cab
chs71 is a fault in your sam chassis
eec61 is a fault in your aftertreatment control modulecab29 Thanks this. -
Ok thank you
-
Ok... I guess I wont worry about it either.....Thanks
-
Thank You All
-
You may want to get your eec61 code checked. If you have a def problem, you could run into a severe engine derate
-
The chassis code is usually a light somewhere. Not always, but thats what it usually is. Ive been told it can go off if a trailer light is bad as well, doesnt make a whole lotta sense, but i guess its possible.
-
each of this codes must have sub codes. write them and I will tell you exact problems. I have the code chart for 2012 Cascadia and if you are o/o I can share it.
1fixitman Thanks this.
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
Page 1 of 2