i have a 2008 pro star and at time it wont start i can turn the key and her a click in the fuse box and push the clutch in and have nothing its been to 4 different international shops and has had 4 different starters put in has any one else has had this promblem and does any one know where the safety neutral switch on the clutch is
2008 pro star starting promblems
Discussion in 'International Forum' started by dougm, Apr 8, 2012.
-
-
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
-
C/k the slave selinoid not sure where its at on a prostate.what kinda of trans is it? Eaton sholuld be on the top off the trans in line with shift tower
-
his has a Eaton fuller 10 speed transmission and what gets me today its been starting and yesterday i had to have it pull started after i turned the motor off and sat for 15 min
-
The clutch switch is under the dash up near the hinge of pedal. There is just a square plastic box with 4 wires coming out of it mounted on a bracket next to the pedal arm. The switch is a solid state magnetic type so it doesn't physically make contact with the arm. You have to remove the kick panel around all the pedals to get to it. You really have push the pedal through the firewall it seems sometimes, if you have a floor mat that is restricting the pedal travel, that might be your problem.
-
Clutch switch as what heavyd said. They tend to give alot of starting issues
-
ok update on starting problem, took in to Crawford truck repair in Aberdeen SD and after 2 days trying to figure this out they think they found a problem. there a wire going from back of the dash to the starter that was to small for the amps/voltage so the had to run a new wire and so far its been starting
Heavyd Thanks this.
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.