can anyone tell me if a low voltage alarm will prevent dome lights from working if so can I bypass it
low voltage alarm bypass on 2013 t660
Discussion in 'Kenworth Forum' started by cliffo, Apr 7, 2014.
-
-
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
-
The whole purpose of a low voltage shutdown is to leave you enough juice to start the truck. Start the truck and let it run a little. Then your lights should work. If not you have other problems like a fuse.
-
yes, my dome lights and sleeper lights/outlets stopped working when i had a problem with the Low Voltage Disconnect system.. I bypassed it then a few days later found a broken ground at the batteries that turned out to be the original culprit..removed bypass....i have a freightliner so not sure anything is similar but in my fuse panel on dash is 4 posts with large red wires going to them...if you put a test light to these 1 will not have power, this one was powered by the low volt disconnect,run a jumper from one of the other 3 `hot` posts and you should be golden.....
cliffo Thanks this. -
circuit breaker good only .7 volts on dome light
had same problem on different t660 and dealer bypassed low voltage and worked fine after that only need to bypass temp. for now any advice
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.