2005 w900l cat c15 acert. I have read several post on the issue and still confused. Sometimes when I try to start it starts fine. other times it clicks a couple times then starts. Today however it has refused to start until a few minutes ago when I went and tried it again. I also noticed earlier the solenoid was very hot and there was a funny noise coming from the battery box area. I don't think it is the starter because it sounds/works fine. Not so sure about the solenoid, and the relay I have read about. Where would this be located on my truck?
starting issue
Discussion in 'Kenworth Forum' started by cumminsISB, May 3, 2014.
-
-
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
-
Check to see if you have power on the signal wire to the solenoid on the starter. If you do then you need a starter, if not then it is either the starter relay, located either in the battery box or on the firewall, or a bad key switch.
-
you need a starter asap
-
$275 remain with core exchange,it took me two hrs to swap mine last week.
-
-
-
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.