I am NOT getting any power to the sleeper bunk in my 2012 t660
All the fuses look good
I have bypassed the lvd and I still getting no power, am I missing a switch somewhere to power everything on?
The main dome light works, but no accessory light, no fridge, no hvac or anything else,
Any ideas where to go with this?
2012 t660 no bunk power, lvd bypassed
Discussion in 'Kenworth Forum' started by BlakusDingus, Jan 18, 2015.
Page 1 of 2
-
-
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
-
ok what is the LVD? did you check the fuses for the bunk under the bed?
-
Newer KW's may have a second fuse box, usually in the left side storage compartment. Have you checked there?
-
-
There is a 40 amp mega fuse in a power distribution panel mounted to the firewall under the hood. I had the same thing happen to my 2014 and had to spend $300 for Kenworth to find the problem. The fuse will cost you about $20.
-
Sorry. it's a 60 amp mega fuse.
This shows the power distribution center under the hood, it's in the center of the firewall above the engine. Snap the cover off and use a wrench or socket to remove the two nuts that hold the fuse in place, then remove and replace the fuse.
This is your replacement fuse and the bag shows the Kenworth part number as well. I bought two of them when mine went out in case it happens again.
Last edited: Jan 18, 2015
Annie M Hank and QUALITYTRUCK Thank this. -
Larger bunks like the studio sleeper have a separate LVD for the bunk
-
Barcelona1971 Thanks this.
-
-
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
Page 1 of 2