Results 11,491 to 11,500 of 30874
Thread: Where are you
- 05.22.2011 #11491Rookie Skateboarder
- Member Since
- Dec 2008
- Location
- Jacksonville, Florida
- Trucker?
- 3 Years
- Age
- 40
- Posts
- 1,273
- Thanks
- 213
- Thanked: 769 Times
- My Truckers Blog
- 1
Coors Brewery, Golden, CO!
- 05.22.2011 #11492
- 05.22.2011 #11493Last Few of the OUTLAWS
- Member Since
- Jan 2010
- Location
- Hesperia, Ca.
- Trucker?
- 32 Years
- Age
- 52
- Posts
- 1,848
- Thanks
- 1,263
- Thanked: 967 Times
At the home 20, celebrating my 50th B-day

which was on Friday and still going until Sunday in the pm, then it's recovery time.
-
- 05.22.2011 #11494
-
The Following User Says Thank You to Les2 For This Useful Post:
- 05.22.2011 #11495
- 05.22.2011 #11496
-
The Following 4 Users Say Thank You to ironpony For This Useful Post:
- 05.22.2011 #11497I'm Vintage
- Member Since
- May 2009
- Location
- Between Valhalla and Hades
- Trucker?
- No Answer
- Posts
- 3,764
- Thanks
- 8,162
- Thanked: 6,512 Times
- My Truckers Blog
- 3
Happy Birthday a little late, Dave. Hope the recovery phase goes well for ya.
-
The Following User Says Thank You to teddy_bear6506 For This Useful Post:
- 05.22.2011 #11498
-
The Following User Says Thank You to ironpony For This Useful Post:
- 05.22.2011 #11499I'm Vintage
- Member Since
- May 2009
- Location
- Between Valhalla and Hades
- Trucker?
- No Answer
- Posts
- 3,764
- Thanks
- 8,162
- Thanked: 6,512 Times
- My Truckers Blog
- 3
Les, did you ever get that swing set finished or are you trapped somewhere inside the jungle gym

- 05.22.2011 #11500Banned or Retired
- Member Since
- May 2010
- Location
- West o' the Big Crick
- Trucker?
- 5 Years
- Age
- 44
- Posts
- 8,934
- Thanks
- 9,450
- Thanked: 9,558 Times
- My Truckers Blog
- 1
Loks like I'll be installing that Right-Weigh after all. The wires are hooked up and the dash readout has the rear axle load display, but it claims my load is 500 pounds. Whether I have a loaded trailer or am bobtail. It doesn't work. I am not that technically educated, so I have no idea whether I need to look for a fuse or broken wire, calibrate it (or how to calibrate it) or if it's more programming stuff in the ECM. This is why I get frustrated with computers. With the mechanical gauge, eiher it's hooked up right or it's not. Either the needle is frozen or it's not. Much more cut and dried.
Read: majorly disapointed. This in-dash readout would have been nice. If it worked.
On my way through Cincy, Louisville and then Nashville. Maybe I'll talk to the shop at the Tee-Yay in Antioch about it that gauge.

Reply With Quote

Petty, BS tickets by DOT getting out of hand
29 Minutes Ago in Experienced Truckers' Advice