The fan on the cats doesn't kick on until 212 degrees.
oce you have the trans stabbed into the clutch plates a couple inches assuming you have allready leveled it then you just jack the trans up a tad...
The biggest thing I try to teach the guys is that when you pull it out have your jack adjusted to the tranny, then they go right back in like they...
The shop[ I just left was a pretty good size shop and we were doing about 10 clutch jobs a week, sometimes 1/2 dozen in 1 day. I l always set mine...
You should not have to remove that grease fitting. When you adjust the clutch what you are doing is adjusting the gap in your clutch brake to the...
I installed a 14" copper tune on my air blower. I drop the pipe from bottom of muffler and stick the blower inside the muffler and blow it out...
A lot of the mechanics that worked for me before I retired would spend a lot of time fighting transmissions when they were stabbing them because...
Does it go over 1500 when driving, some will not rev over 1500 if not moving in gear.
Well, if you are near Los Angeles I may be able to help you out or get one of my buddies who can. I am about 95% retired.
Thats the unloader valve, I would get an unloader kit and give it a try. You don't have to time the fuel pump on that engine.
I have been retired for a while so am a bit rusty but have them look for codes indicating uneven back pressure. Once that code has been set it can...
That particular compressor has had a lot of failures and short life span. I have changed a lot of them at less than 100,000 mi. The failure seems...
Sometimes you can drop the pipe off the bottom of the muffler and use a long air blower to blow the soot out of the bottom screen. All the codes...
Hi all, recently retired truck mechanic who just enjoys truck chat. Name is Steve I go by Badger