losing prime after sitting is a sign of bad chaeck valves. You could also have a internal leak inside the filter base with a crack between the...
Another issue is the wiring harness going to the A/C high pressure switch. The high pressure switch is a trigger signal to the ECM to bring the...
They have the exact same flow rate, so no power difference. The MBN has a larger sack on the tip for the orifices different shape. Other than that...
The C-16 crankshaft will drop in a 6NZ C-15 block. The advantage of the C-16 parts will be torque. The extra 50 Hp and 200 lb-ft of torque is...
That is normal. A 10 psi drop would have me concerned and looking at bearings
If anybody thinks they can install a 6NZ cam in a stock MBN engine without changing the file in the ECM to a 6NZ...
If the air compressor spit those parts out......it wouldn't be just pushing oil. I'm not a detroit person, but I'd say the Freightliner mechanic...
Liner protrusion wasn't good if it varied from 0.003 to 0.005 from one end of the block to the other. It is a blown head gasket or possibly a...
The valve covers I don't torque. They use a special bolt with a shoulder, when they bottom out against the valve cover spacer I stop tightening...
It depends on which set of bolts you have holding the jakes and rockers shafts in place. If you have all 12 point bolts, then it is torque...
The A/C high pressure switch uses a ground as a signal to the ECM to turn the fan ON/OFF. More then likely you have a wire that has rubbed through...
The Acert 475Hp and higher Hp engines with an 1850 torque output rating require two 10" diameter mufflers to reduce exhaust restrictions through...
Did you disassemble and clean the intake air filter piping out from the turbo to the air cleaners, before installing the new turbo??? Did you...
I'll send you a PM
What are you trying to do? The only thing you can do for the compressor side is build the turbo with the compressor wheel for the Hp needed....
Full Tilt and Bully Dog manifolds are the same manifold and it is an aftermarket design. PDI casts their own aftermarket design. All three sell a...
I'd bet on a head gasket. This means a liner sunk. The $2700 will not include the time or labor to cut the counter bores and shim the liners back up.
Has the camshaft ever been changed in this truck? Has the ECM been updated recently with a new file? If you say yes to either of these...
This is more expensive, but the product holds up longer. http://www.atpwrap.com/
Cat engines use oil pressure in relationship to boost pressure to figure out engine load and whether or not the oil pressure is high enough for...