Yeah, I can't help you since I don't know how those mods work, but a guy by the name of Kriechbaum has released mods for most popular trucks, both...
Just need to know something about the cities listed below the logo on some Landstar trucks. I've seen some images with another city listed before...
Nope. Even without the interaxle lock engaged, if the drives have more traction they can push the truck straight in spite of steering angle....
When you say the fan run when the fuel temp wire is removed, do you mean constantly or just more often? A loss of signal from the fuel temp...
So... many... words... Pretty dry reading material for my lunch, but greatly appreciated. I thought. I had a pretty clear picture of the...
Phones exsist for a reason. If you call them, they might, I dunno, pay for their oversight. If you wreck the locking cap to get it off, you'll...
Doesn't it seem to reason that the primary route of torque is ALWAYS across the rear drive shaft? I mean, the first tire to slip in evenly low...
Center the heaviest skids and work each way will usually work. If you are pulling a spead its pretty easy since you can play a little bit heavier...
A PENDING FINE IS NOT A PENDING CHARGE! If the sentence is already handled, the matter is settled. Everyone seems to think this guy has to...
If you only have a fine to pay, and all the legal matters have been handled, I don't see an issue. I assume you missed the date and then received...
After delivering groceries to stores and hauling equipment into food plants for a few years, that looks easy enough. I put 53s and a W9 into...
Well, just thinking, I could likely get 6' ahead of the KP, 20' out the rear, making 94' to the rear of the trailer. Ball park the rear axle at...
Bidding a series of loads from south central Kansas to Great Falls, MT. Crane beams that are 120' long by 5' wide and about 5' tall. One beam...
As far as how early to show up and why, that's also dependant on the operation. One place I haul out of you grab preloaded trailers. If you...
Probably the control rod from the sleeper to the frame as it is prone to making a hell of a racket when the bushing wear. Sounds like a hammer...
Pretty sure there is a bulletin on this for the 18s. Get a new nut and torque to 500ft/lb. Thats eatons solution if there aren't any other...
When I drove for a co they had meritor 10s in columbias and I could never really nail them down. The one they had with a eaton 10 was fine, as...
JRS Travel Center in okc. Old Pilot, and it is rough. I only stop there for the food. The fast food joint has been converted to a Indian...
Many thanks for the info. I found it in Mansfield, OH a few blocks from where I used to live. I wouldn't wanna use it to run loaded with. At...
Spotted this oldy near where I used to live in Ohio. Its just sitting, and has been for a while, near as I can tell. Never have seen another...