Those codes only pop up when i put the truuck into diagnostic mode with scan tool hooked up. The fuel injection pressure is only 20 psi sometimes...
The last time hooked up to the truck codes sid 154, sid 155, sid 248 were retreived. The scanner had no defenitions. when the vehicle was blink...
Hooked up scan tool to truck no codes pulled with scanner at time. The CPS/CMP sensor has been replaced. The IPR valve has also been replaced. I...
The truck started and ran fine for about 4 hours drove it and then i t just died after i made a corner. i replaced the relays the second time and...
The international ran fine for about 2 hours would occasionally sputter here and there. Finally died again and will not start. Same codes 244 and...
The boost pressures are you 0 at idle and the last one the our driver told me was 16 pulling a excavator on a trailer. There should be a potential...
same truck. pulled the map sensor. checked voltages. there is the 5 volt referance voltage and ground. and 6 volts on what i think is the signal...