Can you get the flash codes out of it?
And I thought 149 Detroits were the only engines with crankcase pressure sensors.
I think it is a fault with the coolant level sensor.
If speedo reads, but odometer doesn't I would suspect a gauge fault. Check the clutch switch. If this is stuck on, the cruise and Jakes wont work.
What flash code are you getting?
These are both "Non volatile memory" faults with the ECM. They are displayed as flash code 53. Prior to software level 9.0 it used to bring the...
I would contact them again and try to talk to the service manager. Do they work on Detroits with Roadrangers behind them?
The 14L S60 is the current engine here in New Zealand. It has EGR and DPF, but no SCR. I believe it is an EPA07 engine running EPA04 emission...
Is this correct? With both switches off there are wires on the back of both with 4.5v. The wire on the back of the 2cyl switch drops to zero when...
Horton fan is spring applied. It requires air to release. The fan solenoid is normally closed, ie blocks air flow with no power applied. To...
David, I assume this is a DDECIII engine. There are three solenoids that each operate the Jakes on two cylinders. Low is 3 & 4. Orange wire 562...
Have you done all the checks I suggested last week?
Does the tone wheel run true? Is the wheel bearing preload set correctly? Does the sensor go out of adjustment? Have they checked the scope...
Check to make sure that any fan override switches are turned off. Do you have any active engine fault codes? Is the engine idling at its normal...
When you pull the fuse does the dash also turn off, or does just the engine stop? What voltage is at each end of the fuse holder once the engine...
If you are having a good run with the S60's and your mechanics are familiar with them I wouldn't change.
Sorry, the fuse I am referring to is the one that you have to pull out to stop the engine. I can't see how the fuses in the battery box would...
What is this fuse labelled as, eg gauges, wipers etc? When you pull the fuse does the dash also turn off, or does just the engine stop? What...
The CPC parameter is PGR010/004. Should be set to "0. Disable". Yours is probably set to "1. Enable automatic engine brake with service brakes"....
I would guess that the ignition supply wires to the ECM and dash are not going off when you turn the key off. Are the temperature gauges and...