Driver came to the shop today and told me that as he was slowing down for a stop sign ahead. Driving on slippery snow covered road he put the...
I am working on a 2018 Mack CXU613, the passenger side headlight is not working. The problem is there is no power being supplied to the main Hood...
it has water taps on the engine and i have turned them all off, im gonna have a closer look at the evap core for cleanliness
insufficient cold air, seems to have plenty of air flow!
I have recently replaced the a/c compressor, dryer and a few lines, vac and fully charged the system but I'm finding my dash temp is poor( 65-70)...
we've done plenty of those, take your time and you'll get them out. most times drilling and installing heli coils is the answer. I have had some...
I have never seen the liner shim cause a problem, once the liner is seated in the block with the head torqued down the liners cannot move. Now all...
Now that you mention boost leak the driver has mentioned the sound of boost leak but we have never been able to track it down. Said it comes and goes.
does the oil pressure go back to normal after an oil and filter change than drop off after 1500-3000 miles?
check the harness that crosses over the valve cover they often rub there. your looking for green wires i believe.
I was wondering if anyone has had to deal with a maxforce 13 (2010 emmisions) it will not do passive regens while driving down the road or is is...
sounds like a bad wire between the freeze switch and compressor what year 9400I?
I would check the freeze switch next. it's located under the passenger seat. two green wires going to it and has temp probe that goes into the...
This problem could be caused by a few things. you could have have a high pressure oil leak (HEUI) under the valve cover, ie injector o ring, or...
it is normal, it's part of fast warm up stategy in the programing, and it helps reduce aftertreatment problems. you would think they would let it...
Always replaced with reman cummins parts. Flushed and new rad cap everytime.
Wondering if anyone has ever had repeat water pump failure on n14. The original one lasted 7 years now I changed three in six months. What gives?...
2009 int 9900i with isx keeps coming in with same code "doser condition exists" it has new dpf doc differential pressure sensor, tubes have been...
Drop in all the way, everything is new. you have warranty again. That engine doesn't owe you anything and is good for 100% core value. Replace the...
At this point I would strongly recomend checking the static injection timing. It's a procedure that requires some special tooling that every...