cummins stock flashes will limit there are other ways to tune without the limits.
I have made 600hp to the ground with a n14 that started as 430 i beleave it was with no parts at all and yes his is 350 so 500 is not going to be...
435hp 1650 from tmi 1995
Has any of you had the valves adjusted lately? I did one that would only get 29 psi after valves adjusted went to 45psi. What happens is the...
I can make it put out the power with just program in ecu but will need rebuilt with parts from 500hp would be the best.
Someone programmed the engine ecu wrong. It's programmed to autostart and you probably don't have auto start.
Is your ride higth correct?
I would say yes that is the unloader the line needs to be connected.
I could help you with problem
To check it start with cold engine. Start it up and let it warm up. If the upper hose gets warm or hot at all before 190 your thermostats are bad...
Did they update the ecm for any reason? Have they checked fuel pressure while under a load? Check to see if boost sensor is reading right? I have...
If it is on in the ecm it would likely throw a fault code for it.
Yes it would
Is it detroit motor or cummins?
Does it change at all? If not it probably is shut off in the ecm. There is turbo outlet temp and intake temp but no intercooler temp.
Does the rpm gauge move when you crank it over? If so ecm is working. If not and you get flashes from check engine lamp my be camshaft position...
Where you from i am in MD you stop by my shop i can hook up and check her out.
Hard to say without fault code so much with these systems
Make sure regen system is in good operating condition. Has been serviced recently?
I have seen 60 psi on accert with 550hh program and good fls and fts settings. But the valves have to be in good adjustment and the ivas and...