Hi there.........I have a Kenworth T800 and recently my brake light have stayed stuck on. I checked the plunger on the brake and it seems to be going up and down. I noticed if i bleed the air pressure out to almost zero it sends a signal and lights turn off? I dont know what it can be???? Any help or guidance is appreciated.
Kenworth T800 Brake lights
Discussion in 'Kenworth Forum' started by jr33187, Jul 25, 2015.
-
-
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
-
Brake light switch is sticking on.
-
Yes........ turn off when i start to bleed air from system
-
What I mean is that is likely the problem. Behind the dash panel there will be a couple of air swiches & one of these is for the brake lights.
When the brake lights are on use a test light to find out which one it is & unplug it to see if they go off.
You could also go to the dealer & find out which one it is & just replace it,they aren't very expensive. -
Last edited by a moderator: Jul 26, 2015
-
There are at least two brake light switches, primary and secondary, plus other air switches.
-
Are they under the hood? I found one behind the dash.
-
Is this the primary? Behind the dash
Attached Files:
-
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.