Hello, I have a 2007 International 9200i with ACERT CAT C13 engine. Can someone decipher this code:
J128S032MA J136S001SA J13 Engine #1 ( MID 128 ) reports Turbocharger #1 Wastegate drive (SID 32 is Mechanical Not responding.
I already had the turbo replaced costing me $$ but I'm still concerned that this still shows up as an error once in awhile after the new turbo is placed in. Any other areas I should look at? Or does the computer just need to be reset?
Replaced turbo but error still shows
Discussion in 'International Forum' started by gabton-tankers, Jul 30, 2015.
-
-
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
-
Not sure if this will work on a big truck, but it won't cost anything. Disconnect the batteries, it might put the computer in learning mode when you reconnect battery.
-
-
I'm not real familiar with the c13 but I would disconnect the air line running to it from the vgt box while running and see if you got air coming out of it to operate the actuator.
Have you checked to see what your boost psi and manifold pressure is?
I can pull out the manual at work for it tomorrow and check on the code diagnostics, but that is where I would start. -
JS28S031MA J136S001SA J13 Engine #1 (MID 128) Reports Turbocharger #1 Wastegate Drive (SID 32) is Mechnical system not responding.
I replaced with a new turbo and this error still pops up once in awhile. Any thoughts on what I should check next? -
Where and how are you getting those codes?
-
If your reading this from the dash faults don't worry about it unless you get a check light.
Heavyd Thanks this. -
-
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.