If the light came on after having the filters changed first thing I would check is the plug and wires at the sensor. You have a wiring problem not a filter problem.
Cummins isx fault codes defined
Discussion in 'Trucks [ Eighteen Wheelers ]' started by VisionLogistics, Mar 20, 2012.
Page 2 of 4
-
-
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
-
Cleaned plug and connection with contact cleaner, drove 10 minutes and light went out. Sometimes lady luck smiles on us! Still going to replace filter with Napa sooner than later.
-
I am getting this code on a couple of my trucks that both have an ISX engine in them. But i cannot find any information on why i would be getting this. Engine #1 (MID 128) reports Engine Automatic Start Failed (Engine) (SID 124) is Failure mode not identifiable (FMI 11)
-
Someone programmed the engine ecu wrong. It's programmed to autostart and you probably don't have auto start.
-
I have a 2014 Kenworth W900 isx 525 . I have warning says High Fuel Leakage
-
Hey guys.i have a problem with 2185 code.what is the meaning of this I can't understand.can you guys help me?
-
This is basically a fault in your throttle pedal circuit. ECM is seeing voltage too high in the 5 volt supply circuit. Normally the ECM supplies the pedal with 5 volts but the ECM is detecting a higher voltage likely due from a short circuit with another wire that is probably 12 volts. This is usually on the OEM side, and not inside the Cummins harness.
SAtZ89 Thanks this. -
Hey guys can u help me? I can't understand what is 2185 fault code.it says that sensor 4 circuit.but I couldn't find it.can you suggest me where it is?
-
Hey guys.i have a problem with 1696 code.what is the meaning of this I can't understand.can you guys help me?
-
Hey guys new here. Thanks in advance for the help. Have a 2010 pete 386 with cummins. The dash screen said current sensor fault. Can't find anything on the web.
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
Page 2 of 4