Truckers' Trucking Forum | Message Board | Discussion - The Premier Truck Drivers Forum!  

Trucker MySpace - Truckers Making Friends. Chicken Truckers Come Meet Other Truckers!

Good Trucking Jobs - Forget Those CRAP Trucking Jobs & Find A Good Trucking Job!




Go Back   Truckers' Trucking Forum | Message Board | Discussion > The Garage > Trucks [ Eighteen Wheelers ]

Truckers' Trucking Forum/Message Board - The Premiere Truck Driver Forum
Sponsored Links

Important Truckers Forum Notice!

Trucks [ Eighteen Wheelers ] Roll On Big Mama. Forum/Discussion about Eighteen Wheeler Trucks. What truck do you like or dislike? Is your favorite truck a Mack, Peterbilt, Kenworth, Marmon, Volvo or Freightliner? Which diesel engine do you prefer; Detroit Diesel, Cummins, or...

Reply
 
Thread Tools Rate Thread Display Modes
  ^ Top   #51  
Old 07.23.2008
830hp C16's Avatar
Light Load Member
 
Last Seen: 1 Minute Ago 01.37 PM
Member Since: Jun 2008
Location: New Zealand
Trucker? 20 Years
Age: 38
Posts: 188
My Trucking Photos: 0

Thanks: 18
Thanked: 24 Times
Its a bit harder than I thought tracking down a B manifold found a lot of dead ones.My turbo and injector man hasnt got back to me yet
Reply With Quote
Remove This Ad By Registering. Join Our Truck Forum and Trucking Community For Free. Sponsored Links:

  ^ Top   #52  
Old 07.23.2008
550hpW900L's Avatar
Truck Forum Supporter
 
Last Seen: 1 Hour Ago 12.02 PM
Member Since: Jan 2008
Location: Watervliet, MI
Trucker? WannaBe
Age: 24
Posts: 4,553
My Trucking Photos: 0

Thanks: 213
Thanked: 597 Times
Well if you have deep pockets and want to buy new my suggestion is the C-18 millitary truck manifold. Part #'s are 101-7354 for the center section and 102-8606 for the two ends.

These flow a little better then the B model, but are $$$. Get some wires on the motor too, fuel temp wire and boost wire for response. If you have not then set the injector trim codes to 5232, these are good for 50hp. Also the fuel temp wire is good for another 50hp.

Now you can try these 6969, these trim codes are supposed to be good for 20 hp over the 5232, so 70hp gain. Its been proven by Antrims diesel on the dyno, but i have not tried it yet myself.
__________________


LOAD EM LIKE RAIL CARS, DRIVE EM LIKE RACE CARS!!!!
Reply With Quote
  ^ Top   #53  
Old 07.23.2008
830hp C16's Avatar
Light Load Member
 
Last Seen: 1 Minute Ago 01.37 PM
Member Since: Jun 2008
Location: New Zealand
Trucker? 20 Years
Age: 38
Posts: 188
My Trucking Photos: 0

Thanks: 18
Thanked: 24 Times
Thanks,I will try the 5232 codes not so much for hp at the moment it ldles a bit rough this might make it smoother.I found a B manifold so I will put that on as soon as I can,should I change those inserts on the manifold gaskets?? I have had problems with them before getting to hot and breaking off going through the turbo but CAT have assure me they have fixed that problem
Reply With Quote
  ^ Top   #54  
Old 07.23.2008
550hpW900L's Avatar
Truck Forum Supporter
 
Last Seen: 1 Hour Ago 12.02 PM
Member Since: Jan 2008
Location: Watervliet, MI
Trucker? WannaBe
Age: 24
Posts: 4,553
My Trucking Photos: 0

Thanks: 213
Thanked: 597 Times
Yes i will give ya a list of things,

The exhaust sleeves that go inside the head..part #194-8124..6 required

Gaskets.......... #129-9452......6 required

and the short stud that you will have to put on cylinder 3

short stud......... #4S-6137.....1 required
__________________


LOAD EM LIKE RAIL CARS, DRIVE EM LIKE RACE CARS!!!!
Reply With Quote
  ^ Top   #55  
Old 07.23.2008
550hpW900L's Avatar
Truck Forum Supporter
 
Last Seen: 1 Hour Ago 12.02 PM
Member Since: Jan 2008
Location: Watervliet, MI
Trucker? WannaBe
Age: 24
Posts: 4,553
My Trucking Photos: 0

Thanks: 213
Thanked: 597 Times
It will idle rough with the injectors you have, all that fuel ya got going to the motor
These codes wont make it any better but add power.
__________________


LOAD EM LIKE RAIL CARS, DRIVE EM LIKE RACE CARS!!!!
Reply With Quote
  ^ Top   #56  
Old 07.23.2008
830hp C16's Avatar
Light Load Member
 
Last Seen: 1 Minute Ago 01.37 PM
Member Since: Jun 2008
Location: New Zealand
Trucker? 20 Years
Age: 38
Posts: 188
My Trucking Photos: 0

Thanks: 18
Thanked: 24 Times
Thanks,I will get on to that,one other thing when I change gear I get black smoke{looks good} then burns clean obviously a bit of turbo lag BUT if the turbo was too small wouldnt it smoke under full load at 1800rpm not keeping up with the injectors??
All you get is a heat haze.
Reply With Quote
Remove This Ad By Registering. Join Our Truck Forum and Trucking Community For Free. Sponsored Links:

  ^ Top   #57  
Old 07.23.2008
550hpW900L's Avatar
Truck Forum Supporter
 
Last Seen: 1 Hour Ago 12.02 PM
Member Since: Jan 2008
Location: Watervliet, MI
Trucker? WannaBe
Age: 24
Posts: 4,553
My Trucking Photos: 0

Thanks: 213
Thanked: 597 Times
Hmmm, not nessecerily. Can you get the injector part # for me. If these are 10R-0959's then it will smoke pretty good. I flow so much air for the fuel and it still smokes a lot.

Id like to know what injectors he sold ya, he could got you the 10R-0958's which are smaller. But if you dont push enough air for the fuel it wont smoke heavily, just slight black smoke. Once you build serious power it will smoke no matter what you do. Get the B model manifold on, if that doesent get you within a safe EGT range then im sure you are out of air flow, but im sure the manifold will solve your EGT problem if you got enough turbo.

This is how mine smokes. [LINK POSTED BY MEMBER] Only Members Can View This Truck Forum Link.

A guy i know, its a old freighshaker with a C-15 550 putting down 928hp on CAT parts and i think he did 1100hp with a pittburgh box on top of the injectors.
__________________


LOAD EM LIKE RAIL CARS, DRIVE EM LIKE RACE CARS!!!!
Reply With Quote
  ^ Top   #58  
Old 07.23.2008
MedicineMan's Avatar
Solution Finder
 
Last Seen: 2 Minutes Ago 01.35 PM
Member Since: Jan 2007
Location: Woodville, TX
Trucker? 13 Years
Age: 34
Posts: 7,873
My Trucking Photos: 4

Thanks: 6
Thanked: 664 Times
I like that truck allot.
Reply With Quote
  ^ Top   #59  
Old 07.23.2008
830hp C16's Avatar
Light Load Member
 
Last Seen: 1 Minute Ago 01.37 PM
Member Since: Jun 2008
Location: New Zealand
Trucker? 20 Years
Age: 38
Posts: 188
My Trucking Photos: 0

Thanks: 18
Thanked: 24 Times
I did right down all the numbers on the injectors:08C6B69 or 2815610 not sure which one is the part number.
Reply With Quote
  ^ Top   #60  
Old 07.23.2008
830hp C16's Avatar
Light Load Member
 
Last Seen: 1 Minute Ago 01.37 PM
Member Since: Jun 2008
Location: New Zealand
Trucker? 20 Years
Age: 38
Posts: 188
My Trucking Photos: 0

Thanks: 18
Thanked: 24 Times
LOL,WOW I thought mine smoked I got nothing on that!!!!
Reply With Quote
Reply

Truckers Forum Bookmarks - Like This Thread? Tell The World!

Truckers' Trucking Forum/Message Board
Truckers Accessories


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools
Display Modes Rate This Thread
Rate This Thread:

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are Off
Forum Jump

Similar Threads
Thread Thread Starter Trucker Forum Replies Last Post
Swift Transportation Company, Inc. - Phoenix, Az. TurboTrucker Report A BAD Trucking Company Here 1023 20 Hours Ago 05.28 PM
JB Hunt - Lowell, Ar. WiseOne Report A BAD Trucking Company Here 1237 10.06.2008 11.30 AM
Getting Better Fuel Mileage maxeffort Trucks [ Eighteen Wheelers ] 62 09.14.2008 01.13 AM
Ways to Increase fuel mileage. drfuller18 Ask An Owner Operator 33 06.07.2008 05.37 PM
Real devices/additives that will save on Fuel gas mileage? ybfjax Questions From New Drivers 21 03.05.2008 03.37 PM


.


vBulletin Forum Software, Copyright ©2000 - 2008, Jelsoft Enterprises Limited.
Copyright © The Truckers Report - Trucking Forum & Message Board - Truck Driver Discussion - Truck Forum

Trucker Forum Disclaimer: All content, information and opinions (collectively, the "Material") presented on Our Trucker Forum Discussion Board at TheTruckersReport.com are those of the authors of posts and messages (collectively, the "participants") and not The Truckers Report. The Truckers Report does not guarantee the reliability, completeness, accuracy, timeliness or up-to-date-ness of the material presented on the Truck Driver Forum. The material is published "as is," and does not represent the official views and opinions of The Truckers Report or any company. Any reliance upon the Material presented on these forums shall be at User's own risk. The Truckers Report does not review the substance of the content posted by users on these forums and is therefore not responsible for any of such content. The Truckers Forum merely provides a space for its users to express and exchange their own opinions.


Search Engine Friendly URLs by vBSEO