both sensors are new, vcads shows engine speed and while doing balancing test I got 2 cylinder -50% and 5 cylinder +50% all other cylinders were around -/+ 15%.. cylinder pressure test shows 92% up to 98%
why I got that MID144 PSID200 FMI9 code??
MID 128 SID 231 FM2 error code.. what does it mean and how to fix it??
Discussion in 'Volvo Forum' started by bravoo67, Jun 14, 2012.
Page 2 of 6
-
-
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
-
it is time to change injectors with new......bravoo67 Thanks this. -
will change them this week.. Thank you Pablo !!!!
-
-
BTW, do not forget enter trim codes (with 4 pin delphi injectors) and reset cyl. ball. values to zero and let ECM rebalnce engine
bravoo67 Thanks this. -
will do .. thank you Pablo
and the fuel rate is 0.5 -0.6 g/h with average of 4.5 mpg
probably Wednesday I will have injectors .. cant wait to see the difference -
some comments
ABS unit is Wabco ABS-E frame box, made in Wrozlaw, Poland))) But you cant get info about unit on Wabco portal, becouse fram box 202 0 is used on Volvo trucks and only thing you can get - Wabco Diagnostic software for ABS-D+
Eaton newer reads its info. You have to use Service Ranger software. TT cant help too.
VECU is like on any Version-II truck. Engine ECM is newer with two horizontal connectors, it is used with twin solenoid injectors (Delphi)bravoo67 Thanks this. -
bravoo67 Thanks this.
-
yes I have Delphi injectors.. so everything seems to be normal ?? no miss communication?
Thank you again!
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
Page 2 of 6