1997 Pete 379 N14 Redtop (low fluid light comes on then stop engine then dies for a second

Going down the road or at idle

Low fluid light comes on then stop engine light then truck loses power for a second then picks back up. At idle it will do this but catch itself before completely turning off.

Only fault is High Oil Temp, sensor doesnt work. This truck doesnt have a coolant level sensor. Oil pressure is good (use to have that fault but changed the sensor)

Temp sensor is one wire going to oil pan. (can that make it stop) coolant level plug is open not plugged into anything, no low pressure oil codes, just did oil change.

Any ideas would help Thanks in advance.

 

If I lost ecm wouldnt that clear the faults? Plus would that make the low fluids light come on and stop engine light come on.

 

I checked my batteries grabbed every wire to tug on them moved ever sensor around trying to make it cut off and pulled on the ground wires nothing so far. I fixed 3 wires that were damaged 2 going to the position sensor under compressor and 1 next to it a 2prog. Just sent drive to get inactive codes pulled.

 

Keep trucking app shows road speed sensor and oil temp only . Truck only shows 241 road speed not the oil temp.

 

Ok just died at the shop no check engine light will crank but not start I know check engine needs to cycle first so this time it wont come on.