Post flatbed load photos here V2.0

You’d be surprised how many places don’t.

 

No. I thought they were required but the place they loaded at and the guy training him said they weren’t required but they’ll put a bevel on this set. Supposedly they were 80$ a puece

 

$80,000 coil vs $80 piece of wood

Makes sense

 

Securement looks good. But that tarp may get cut on the edge of the coil, they need another blanket, or a bigger one. Just my opinion.

 

They threw three over it

 

I love rookie forklift drivers.

Billed back to drop off location, paid in 10 minutes of getting the invoice.

 

Darn that sucks…

 

How do you figure up a cost on that? Call a local welder and get a quote?

 

No edge protectors, either? The thing about the lumber, though, I don't think comes down to the co. preference, it seems it's more codified in the 'crib' requirement of keeping the coil from being able to roll. Unbeveled lumber can be used with those HD coil bunks with the 3 different angles for the plain lumber to sit in. Plus, there is less chance of coil damage with beveled angle for the wood, which usually also has friction mat/rubber that the coil sits on it helping to protect coil and resist movement.

 

I knew the price on the pipe stakes since I just got them made a week before.

The pockets I just 100% guessed.
$50 for the steak and $500 for the other damage.