The company im leased to decided to cut the wire coating right at the pigtail(Aftermarket lane guidance system).. I had just enough room to put a heat shrink connector on it. But the hood part i put heat shrink connector and wrap and loom around it.
This is how the shop did the wire connection -.-
Kenworth T680
Discussion in 'Trucks [ Eighteen Wheelers ]' started by TruckerPete1990, May 22, 2022.
Page 2 of 2
-
rollin coal and Another Canadian driver Thank this.
-
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
-
The whole harness should be protected.
I just ordered from the factory all my harnesses to be protected.
I'm very happy about it.
It really paid off. -
Another Canadian driver Thanks this.
-
I have the pins and connectors because we have such an issue on the T880. I like to wrap the harness with a cloth harness tape I get from Summit racing and then wrap that with federal mogul nylogard fabric sleeve. You need a hot knife or titanium scissors to cut the stuff
Accidental Trucker Thanks this.
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
Page 2 of 2