Schneider chat room - Closed see new thread linked in the last post

Discussion in 'Schneider' started by TennMan, Dec 14, 2011.

Thread Status:
Not open for further replies.
  1. KE5WDP

    KE5WDP Road Train Member

    1,601
    1,052
    Mar 11, 2010
    Waskom, Texas
    0
    15 degrees or lower, you need to add anti-gel treatment and idle. I've seen way too many trucks froze over cuz they didn't take care of their fuel.

    If your fuel gels, you will likely have to wait til the temps warm up enough to ungel. Depending on how cold it is, it could take days.

    So the way I see it, don't take any chances.
     
  2. Truckers Report Jobs

    Trucking Jobs in 30 seconds

    Every month 400 people find a job with the help of TruckersReport.

  3. Nakmuay

    Nakmuay Heavy Load Member

    913
    117
    Jun 30, 2010
    chattanooga tn
    0
    If u ever get over to Kalifornia get a plate of carne asada fries with sour cream cheese and guacamole thats about as unhealthy as you can get plus u will be in heaven

    quad core project butter smoothness
     
    48Packard Thanks this.
  4. mattfield80

    mattfield80 Light Load Member

    216
    19
    Jun 29, 2012
    Kernersville NC
    0
    good morning guys and gals...can anyone give me an overview of the experienced drivers orientation with SNI? thats what my prospective recruiter told me i would go into should i decide to come back to schnieder. only thing is, ive never done otr work before, just home daily dedicated runs. ive gotten lazy with my pretrip (for schneider standards anyways lol) and i think ive only slid the tandems twice in seven yrs! (i ran flatbeds for the past six) but i guess they consider me experienced lol....any help out there? thanks
     
  5. brooklyn50

    brooklyn50 Light Load Member

    75
    5
    Mar 27, 2007
    Maryland
    0
    I've just completed the experienced orientation It's 2.5 days in length.On your first hour - yep, that quick - you'll take your check ride. Depending on the tester depends on the thoroughness of the PTI, and so on. Afterwards, it's relatively easy with paper work, learning the Schneider system, EOBR, TRans-flo, and so on and so on. You should receive your truck assignment almost immediately upon 'graduation.'

    Hope this helps just a tad. Good luck and welcome back, as it were.
     
  6. 91B20H8

    91B20H8 Road Train Member

    2,946
    3,315
    Oct 17, 2012
    The Heart of the North, Mi
    0
    can anyone give me a heads up to what the "Schneider" pre trip consists of?
     
  7. mattfield80

    mattfield80 Light Load Member

    216
    19
    Jun 29, 2012
    Kernersville NC
    0
    thanks brooklyn....did they give you the prework screen as well? step test, lifting of weights etc? i hope this 2.5 orientation is all ill need. i know how to drive, granted, ive only been in daycabs for the past six yrs so a conventional sleeper may take a very very short bit to get used to again. Also, did they skirt over trip planning any? as stated before ive never had to do it in the seven yrs ive been driving as ive been lucky to have had home daily positions...(leave a 3 am and be done by 3-4 pm or so) thanks
     
  8. brooklyn50

    brooklyn50 Light Load Member

    75
    5
    Mar 27, 2007
    Maryland
    0
    Oops. Forgot about the various exercises they put you through. Yep. Count on it, Matt. If you're in relatively good condition, you'll do just fine. As for daily home times, it all depends on your DBL and the position you get hired at, i.e., dedicated, regional, and so forth.
     
  9. brooklyn50

    brooklyn50 Light Load Member

    75
    5
    Mar 27, 2007
    Maryland
    0
    The PTI, TVI, and Post-trip are detailed in the hand-out and in the Driver's Hand book. Frankly, it's close to what you learn in 'basic' training.
     
    Last edited: Jan 6, 2013
  10. brooklyn50

    brooklyn50 Light Load Member

    75
    5
    Mar 27, 2007
    Maryland
    0
    Matt, when on your check ride, don't hesitate to use as much road/room as you need to make your turns and so forth. When making the left-hand turn onto a 4-lane road, ensure you make your turn into the left-hand lane you're turning into, then change over to the r/h lane after the turn. Again, though, don't hesitate to take as much room/road as you need - and WATCH YOUR TANDEMS, i.e., don't hit any poles, STOP signs, curbs, and so on. Piece of cake. :)
     
  11. mattfield80

    mattfield80 Light Load Member

    216
    19
    Jun 29, 2012
    Kernersville NC
    0
    that dang step test is what bothers me....i know its only 1 minute up and down etc...but right at the one minute mark my knee always irritates me. i can barely do the 1 minute. maybe ill slow my pace a bit when they have me do it...but not tooo slow....
     
  • Truckers Report Jobs

    Trucking Jobs in 30 seconds

    Every month 400 people find a job with the help of TruckersReport.

  • Thread Status:
    Not open for further replies.