mercer transportation

Just pick up a tube of blue rtv gasket maker. Pul that axle up on a 4x4. Loosen the bolts, pull the axle out about an inch, scrape off the old gasket on both surfaces, clean the up real good and put a thin coating of blue rtv gasket maker on it. No need to pull the axle all the way out to get a new gasket on. If you've never done one it can be tricky getting the gear teeth lined up just right. Oh and use an oil jug with the side cut off to catch the gear lube that will drain out. Pulling up on a 4x4 puts the axle housing at enough of an angle that you won't have to catch much lube.

 

that's a really good tip with the 4x4

 

There was a glitch at Qualcomm , email sent out by my coordinator that the problem should have been corrected by noon today.

 

Question... if I put bars stop leak in will that mess up my system? Will it fix a liner leak lol?

 

Best stuff to use is at loves blue bottle l think its called kd stop leak better than barrs

 

Will it hurt my system? Don't wanna put it in and start running hot lol

 

Should be fine, my kid put it a cat in concrete truck, used and abused everyday. Stopped it

 

Has anyone noticed if you commit to a load on the board, it will show you if someone ahead of you is preselected on it, used to have to call coordinator on that.

But with that does anyone have any operational issues or glitches , I could pass on to IT?

 

Yeah tell them to fix the app so it stops going down on Mondays

 

I suggest NOT using any stop leak. It will plug up your radiator. The tubes are so small in the low flow systems that you would be asking for more problems. But it's your truck.