I have a 2005 International, with the Cummins ISX15 and an Eaton 10 shooter that would cut out on me intermittently; stop engine light on along with all lights and accessories, and would resuscitate itself after a few seconds and merrily roll the milage back while doing so.
So when I bought this truck and upon opening the hood the first thing that caught my attention was a red wire laying across the top of the engine and spliced into the white power wire of the 4 prong connector that plugs into the ecm. I've been turning wrenches for a good many years so I know a WTF when I see one !! The owner had no knowledge of mechanics or trucking and had invested into a trucking business and was learning the hard way why that was a mistake. Anyways, I bought the truck drove it for a short while without incident until the nickel and dime gremlins felt I had worked long enough to start tapping into my financial happiness. So this intermittent cutout happened for probably 2-4 weeks and I tried inspecting and looking but my background was from cars and trucks and I hadn't yet been fully initiated into diesel mechanics the way I am now, painfully so !! I was gonna say pants around my ankles but this truck wanted to hit it every day so I just stopped wearing pants and underwear altogether and just drive the truck in a bath towel. So I pulled into a DC and backed into a parking spot to check in and as I stopped, a huge cloud of smoke came from under the hood and the truck shut off as well. I looked at my temp gauge as I thought maybe it overheated and the gauge/warning was being held hostage by the gremlins. Maybe..blown hose, low coolant, engine shutdown ? Nope, that red wire laying across the top of the engine had rubbed through, grounded out and melted the insulation from one end to the other. I always wondered why it didn't just blow the inline fuse unless the smaller gauge wire had less resistance than the fuse in there. Anyways I replaced that wire and solved the cutting out and odometer retrograde. The wire must have intermittently been touching ground just enough to wreak havoc and not enough to cause a hard failure until it rubbed through far enough. Later, I traced the white wire back to the battery box just behind the DS fuel tank and over the top of the DS air tank (twin forward facing torpedoes) and the 2 wire harness had rubbed through and disintegrated an inch of the white wire and most of the black from not being secured properly. I took the time to do a nice repair on these hoping I could restore the original wiring and get rid of my jerry-rigormortis and when I removed the red wire and tried to start it.....nothing. So I had to leave the red wire hooked up and just wrapped it in duct tape so whatever it touches it won't rub through the insulation. So I would check that power wire up close and personal from one end to the other. You could also try a continuity test to ground while you wiggle it. You have to be grounding the power wire to the ecm somewhere to make it go schizo like that or have internal ecm issues. And if you see a guy walkin around the truck stop in a bath towel, I'm not weird, just overly abused. Come say Hi. I've got some great stories, like the time in VA when the tranny fell out, pulled the shifter out of the top of the tranny when it slid back and off the perches goin down the highway at 60 mph and I was left trying to shift a limp #####.
ISX CM870 randomly shuts down
Discussion in 'International Forum' started by Haulin_regional, Sep 30, 2015.
Page 3 of 3
-
D.Tibbitt, Sani101 and QUALITYTRUCK Thank this.
-
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
-
Nice story!
-
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
-
So, just to be clear. you replaced the ECM wire feed to the batteries? I'm only asking because I'm experiencing it all over again today for the 1st time in a few years. Another ECM was installed in July 2018. since it was the fix last time around. but that didn't solve anything. And then, it disappeared all of a sudden in the fall. This problem is so intermittent that it's makes it almost impossible to diagnose. But you're one of the first that may have found a permanent fix. This issue has haunted me on and off since I've owned this truck and nobody has a solid answer. -
TwoTruckers69 said: ↑We are having same problems. Truck cutting out. Odometer rolling back etc. changed and checked all wires on battery that feed computer Engine warming light still on. Thinking it may be ecm. Not sure what to do next. Anyone help?Click to expand...
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
Page 3 of 3
Related Categories
-
2023 LT
fcfightermma posted Mar 8, 2024
-
MAXXFORCE DT 2012 No Power No...
Legacy_Lopez posted Mar 1, 2024
-
2006 9200 Dash gauges
Helpless posted Feb 29, 2024
-
Wheels, you want wheels?
Spardo posted Feb 18, 2024
-
Washer pump inop and low...
jmlloar posted Feb 14, 2024
-
Maxforce 13 Low Power, will not...
Yippykyae posted Feb 13, 2024
-
2007 international 9900i isx
Bigboi662 posted Feb 7, 2024
-
Batteries test okay, but…cranks...
tarmadilo posted Feb 1, 2024
-
2017 Lonestar Vibration
lonestar244 posted Jan 29, 2024
-
Manual transmission issue
EastHighwayMike posted Jan 26, 2024
Loading...
Recent Threads
-
Upgrading old Eaton auto shift...
AtomicSpud posted Apr 23, 2024 at 1:59 AM
-
You are on the road, using...
Labrador posted Apr 22, 2024 at 11:09 PM
-
New lease purchase driver...
kevinbarcusprior posted Apr 22, 2024 at 8:12 PM
-
Taking Knowledge Test for...
NewTruckerGuy posted Apr 22, 2024 at 7:36 PM
-
Recent grad, Florida
Dirtycup999 posted Apr 22, 2024 at 6:48 PM
-
About Leaving Your Car at a...
NewTruckerGuy posted Apr 22, 2024 at 3:18 PM
-
Seasoned OTR Driver from...
Espey127 posted Apr 22, 2024 at 2:53 PM
-
Illinois
Davehrose1 posted Apr 22, 2024 at 1:47 PM
-
Is ats still a good company?
Vrgadin posted Apr 22, 2024 at 11:32 AM
-
Frustrated Driver In Austin
mjd4277 posted Apr 22, 2024 at 10:13 AM
Loading...