Advantages of a spread axle trailer?

Discussion in 'Questions To Truckers From The General Public' started by Bobg, Feb 12, 2009.

  1. Bugz

    Bugz Bobtail Member

    32
    2
    May 6, 2007
    Oregon
    0
    How about Spread sliders ? I am about to buy a 48' reefer trailer with a spread axle slider. not sure yet what the spread (10'?) is but I now I can close it up and make it tandem, no dump valves that I know of, anyone have experience with these ?
     
  2. Truckers Report Jobs

    Trucking Jobs in 30 seconds

    Every month 400 people find a job with the help of TruckersReport.

  3. Gears

    Gears Trucker Forum STAFF - Gone, But Not Forgotten.

    4,511
    3,184
    Aug 20, 2009
    0
    To resurrect this thread....

    I'm looking at a 53' reefer with spread sliders. I've pulled a 48 with a fixed spread previously and really liked the ride. It wasn't hard to back but I can see where tire scrub played an issue when making tight turn backs.

    I'm intrigued by this dump valve that was mentioned for the forward or rear wheel sets in order to minimize tire scrub. Is this something that has to be added or is it a factory installed standard system?

    One final question, 53' Spread and 53' tandem reefers. The spread has Thermo-King and tandem a Carrier. Same year. The tandem is $1,500 less than the tandem. Worth it to move up to the sliding tandem (it also has aluminums and new recaps)?

    Thanks in advance for your replies...
     
  4. Winchester Magnum

    Winchester Magnum Road Train Member

    1,492
    1,647
    Jan 4, 2009
    Alaska highway
    0
    I personaly would pay the extra $1500 to get the spread. I hate the recaps, but whatever.

    As for the independent dumps on each axle, you can not get that feature from the factory, however I know there are dealers that will install it for you. Perhaps not every dealer though.
     
  5. kajidono

    kajidono Road Train Member

    6,417
    4,659
    Jun 1, 2009
    Streetrat
    0
    I like the spreads too. Better ride and better weight distro. I wish I had dumps on mine though. Watch it with the tight turn backing, you can roll the tire until the bead separates from the rim. Then you get to beat on the rim with a hammer for hours to straighten it out enough to get the tire to seal again. Go ahead, ask me how I know that. :biggrin_2559:
     
    KB3MMX Thanks this.
  6. KB3MMX

    KB3MMX Road Train Member

    3,057
    2,572
    Dec 29, 2014
    Orrstown, PA
    0
    Resurrection again lol

    I'm buying a new utility 53' van with full sliding 10'1" spread.

    Any advice on tires etc? ... Things a newbie to the spread axle world should know?

    Thanks!
     
  • Truckers Report Jobs

    Trucking Jobs in 30 seconds

    Every month 400 people find a job with the help of TruckersReport.