Truckers Report Jobs

Find Trucking Jobs

Company Driver Company Driver Dry Van Dry Van Flatbed Flatbed Refrigerated Refrigerated Specialized Specialized Owner Operator Owner Operator
More Trucking Job Searches ⌄ Fewer Trucking Job Searches
⌃

No crank no start on a Int'l 4300

Discussion in 'International Forum' started by Robbie Walls, Jan 8, 2021.

  1. Jan 8, 2021 #1
    Robbie Walls

    Robbie Walls Bobtail Member

    2
    0
    Jan 8, 2021
    0
    I have a 2002 Int'l 4300 with an Allison Automatic It will not crank when you turn the key it has no park indicator and it says check electrical system I think it's not cranking because the truck doesn't recognize that it's in park Has anybody run across this problem I've changed the neutral safety switch and I've changed the TCM
     
    Robbie Walls, Jan 8, 2021
    Robbie Walls, Jan 8, 2021
    #1
  2. Truckers Report Jobs

    Trucking Jobs in 30 seconds

    Every month 400 people find a job with the help of TruckersReport.

  3. Jan 9, 2021 #2
    Heavyd

    Heavyd Road Train Member

    7,626
    6,027
    Feb 4, 2009
    0
    The transmission is not being detected on the datalink. Check the main trans fuses at the battery box. If they are good, you might have a datalink problem.
     
    Heavyd, Jan 9, 2021
    Heavyd, Jan 9, 2021
    #2
  4. Jan 9, 2021 #3
    Robbie Walls

    Robbie Walls Bobtail Member

    2
    0
    Jan 8, 2021
    0
    Thanks all the fuses are good and I replaced the trans computer and the wiring harness looks good and I checked the shifter and I've had about five people look at it and nobody can figure it at I'm about ready to hunk the truck
     
    Robbie Walls, Jan 9, 2021
    Robbie Walls, Jan 9, 2021
    #3
  5. Jan 10, 2021 #4
    BoxCarKidd

    BoxCarKidd Road Train Member

    4,188
    6,004
    Aug 26, 2014
    0
    Have seen problems with connectors on smaller wires from the batteries on a similar truck. Positive and negative. Finally cut all of them out, soldered and sealed them.
    Testing is recommended to swapping parts.
    Had another one with a bad switch in the parking brake handle assy.
    Another had the transmission wiring to close to the exhaust. Internal meltdown but the outside looked good.
     
    BoxCarKidd, Jan 10, 2021
    BoxCarKidd, Jan 10, 2021
    #4
  7. Jan 22, 2021 #5
    ChuckMartel

    ChuckMartel Light Load Member

    160
    94
    Jan 22, 2021
    0
    Like HeavyD said check those powers and grounds thoroughly from the battery box to the TCM. Also remove the connector at the TCM and check for powers and grounds, load test with headlight if need be.
     
    ChuckMartel, Jan 22, 2021
    ChuckMartel, Jan 22, 2021
    #5
  • Truckers Report Jobs

    Trucking Jobs in 30 seconds

    Every month 400 people find a job with the help of TruckersReport.