Truckers Report Jobs

Find Trucking Jobs

Company Driver Company Driver Dry Van Dry Van Flatbed Flatbed Refrigerated Refrigerated Specialized Specialized Owner Operator Owner Operator
More Trucking Job Searches ⌄ Fewer Trucking Job Searches
⌃

FLD 120 oil pressure buzzer

Discussion in 'Freightliner Forum' started by W Bench Farms, Mar 2, 2021.

  1. Mar 2, 2021 #1
    W Bench Farms

    W Bench Farms Light Load Member

    205
    346
    Oct 16, 2017
    0
    1995 FLD 120 with a Cat 6NZ. Oil pressure on the gauge is steady at 45-50 psi. Going down the highway at 65, the oil pressure light and buzzer will go off. Sometimes l the light is dim, sometimes is full on. I have replaced the sensor on the right side of the engine above the oil cooler. Didn't help. Is there another sensor somewhere? Maybe tied to the gauge feed line? Had the same issue a while back with the over temp sensor, and got that one fixed. This buzzer will drive you nuts!
     
    W Bench Farms, Mar 2, 2021
    W Bench Farms, Mar 2, 2021
    #1
  2. Truckers Report Jobs

    Trucking Jobs in 30 seconds

    Every month 400 people find a job with the help of TruckersReport.

  3. Mar 2, 2021 #2
    SmallPackage

    SmallPackage Road Train Member

    4,521
    13,610
    Dec 20, 2019
    Marion Texas
    0
    On my FL60 with the baby cat that buzzer is the same one as the low air. Both are wired into it and both have another low pressure switch behind the dash in a manifold that activate it.
    Oil line goes into the manifold port where cheap made switch is and comes back out to gauge. Air psi does same. Switches look identical but I assume are set for different psi’s. Both switches run wires to the same buzzer screwed down close to them.

    I’ve had the air psi switch go bad twice and would not shut buzzer off. Haven’t had issues with the oil psi switch yet.

    The FL coe with Cummins parts truck I have is set up the same way so I’d assume your 120 should be the same. Seems to be a FL thing across all models.
     
    SmallPackage, Mar 2, 2021
    SmallPackage, Mar 2, 2021
    #2
    W Bench Farms Thanks this.
  4. Mar 2, 2021 #3
    W Bench Farms

    W Bench Farms Light Load Member

    205
    346
    Oct 16, 2017
    0

    Thanks for the info. I was thinking that might be the case, but didn't want to tear under the dash if it wasn't. I had a switch for the cruise go out in that block, and it was a bear to get to and get out. I'll check it out.
     
    W Bench Farms, Mar 2, 2021
    W Bench Farms, Mar 2, 2021
    #3
  • Truckers Report Jobs

    Trucking Jobs in 30 seconds

    Every month 400 people find a job with the help of TruckersReport.