I'd like to improve the turning radius of my 2004 Pete by turning in the adjustment bolts that are on the backside of the steering hub assembly. Is there a science to how much you turn in the bolts or is it simply trial and error?
Turning radius
Discussion in 'Heavy Duty Diesel Truck Mechanics Forum' started by spindrift, Jun 10, 2021.
-
-
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
-
spindrift Thanks this.
-
The left side will hit first. Check for tire clearance and adjust the left side first. Your actually adjusting the right stop bolt to set the left clearance. I ussually allow 1/2" minimum tire clearance from any object. Once set count the steering wheel turns and set the right side to match the left for same number of turns.
Since your turning sharper you may have to reset the poppets inside the steering gear if find the steering still stops at the previous spots and will not assist to the screw stop. Consult steering service manual. A hard steering wheel pull against the stops ussually does the trick. -
Man that 05 KW mixer I was forced to drive had the turning radius of a guided missile cruiser.
The first time I wheeled into the staging area of the plant I dang near crashed.spindrift Thanks this. -
We drive a 1990 long nose international dump truck that takes a lot of 3 point turns
still a fun truck to driveBoxCarKidd Thanks this.
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.