yes, that's what I read in one of your earlier posts but when I try that.. .it just starts from where my truck is now. I'll keep at it. It does put a little green house where I tell it to "set origin". Then when I go back to *destination* put in that address, it figures the route from where I'm at now.
Suppport Thread for the TND 500, TND 700 or future Rand McNally products.
Discussion in 'Trucking Electronics, Gadgets and Software Forum' started by Mark Kling, Apr 16, 2010.
- Thread Status:
- Not open for further replies.
Page 2 of 756
-
-
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
-
when I find first location (could be anywhere) and hit *set origin* it does go back to the map and the box with the "go back to gps location" does come on but only for a brief second then disappears and I have to hit "back" upper left corner to go to menu and put in 2nd location, hit "begin route" and it routes from where I am now.
-
Try to push the reset button on the back of the TND while it is on... it will turn the TND off and then power the TND back on. Try to do a set origin again and let me know what happens.
Thanks,
Mark -
thanks Mark, it seems fine now
-
Thanks,
Mark -
for now thx
-
There's a Pilot on I-24 in the southern edge of KY that it won't route to. It does the same thing with the weight restriction between the highway and the ts entrance. There's a J at the next exit, I think it's hwy 117. It routes you to that exit then back on a gravel farm road to the previous exit the Pilot is on.
Mark Kling Thanks this. -
Hey Mark..Just heard the commercial on Nemo's show for the TND 700! Sounded good describing some of the features.
Mark Kling Thanks this. -
Thanks,
Mark
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
Page 2 of 756
- Thread Status:
- Not open for further replies.