Suppport Thread for the TND 500, TND 700 or future Rand McNally products.
Discussion in 'Trucking Electronics, Gadgets and Software Forum' started by Mark Kling, Apr 16, 2010.
- Thread Status:
- Not open for further replies.
Page 727 of 756
-
-
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
-
Thanks,
mark -
I decided to hook my 520 up to the computer a few minutes ago to check for any updates. My device was off. I unplugged power cord and plugged in USB cord, when I plugged the USB cord into the computer the device powered up and when it showed it was connected it did something it has never done before.
It said....DING!!!I downloaded an update decided to run the diagnostic and repair. During that my device said DING!!! three more times.
It's loud, it's annoying. I don't need it to do that. I don't want it to do that. Why did it do that? How can I stop it from ever doing that again?!?! -
Thanks,
Mark -
nevermind, I got them working.
I uploaded the Werner Drop Yards file. I tested it on my RM TND 520 LM GPS and works beautifully. Title Names, Addresses all display properly and go to the correct coordinates.
Werner Drop Yards Updated (4/2014)
http://www.poi-factory.com/node/42468 -
Navi exe crashed.
I am quite sure that when you hear a DING that something did not start or load properly. My pc does the same thing once in a while when a program fails to start properly.Ukumfe Thanks this. -
The more PC way would be to turn your TND off, connect to the computer,turn on, then update. Once done, either dismount the TND via safely remove hardware or to turn the TND off and then disconnect.
Remember the TND has programs and files running when you connect it to the computer, this in turn basically somewhat crashes any running programs.
Thanks,
Mark -
Is there any way to change this behaviour as I think maybe you could get a minor power spike happening at times or too many programs trying to start at the same time? -
Sometimes if you disconnect while still on, you may get a systems files missing error message when it boots up. Just turn off the TND, then turn it back on again.
Thanks,
Mark -
I have had numerous instances of my TND turning on when starting my truck, prob an interruption of the accessory circuit making the unit think It was just plugged in,my TND 700 never did this as it did not auto start when plugged it. I know your gonna tell me to unplug the unit before starting the truck but that's a pain and shouldn't be necessary and there again as soon as you plug it in it will start up and then you have to shut it off if you didn't want it running at that time.
There must be a way to stop it from auto starting when plugged in to power?Last edited: Apr 23, 2014
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
Page 727 of 756
- Thread Status:
- Not open for further replies.