Magnetic, battery operated, wide load clearance lights. What's good?

Very nice , where do u wire them into? I have ran wired lights but only a red light bar on back of 60ft rebar and steel. Ground and hot wire ran into back of the trailer.

 

Depending on where you run and what loads.

You might need 2 sets of yellow.

Cali for instance, requires every 20 feet IIRC.

Basically like some trailers that aren't lit up along the entire side. One in the front. One in the middle. Red on the rear.

I used that same plug for wired lights you use for light bar on those 60 ft loads.
I had the wire rolled up for clean and tidy storage.

 

I believe his are battery powered.

 

Try to find a rechargeable kit also for the triple A's.

You're not constantly buying batteries and you'll have em on the charger as needed for use.

 

Som of our trailers have a 4 pin connector on the rear for lights. I also carry a 7 way cable that has a male and a female end with about a foot of cable in between. I tapped into the marker lights and ground wires on one end. This can be used in between the truck and trailer or on the rear of a rgn where the flip axle would go.