Fix it when it breaks. Otherwise continue on
Used to use snapon. Switched to milwaukee and loving it so far. Gotta get the fuel models for the power though.
390 5sp and 2sp axle. Its been a good truck. Its got the good 1st 2nd shift pattern. My dodges have the 1st and 2nd beside each other and suck...
Yes sir. Good eye
Gettin it done old school.
3/8 and 1/2 are standard. 1/4 general service set for cab work. 3/4 and 1 are shop supplied. 3/4 for small yoke nuts ubolts and head bolts. 1...
I have a 3-53 sitting here with your name on it @AModelCat . Bring a jug of whiskey and ill help ya load it
Gotta run em up here. When its -40 its hard to tell if you are in neutral. This truck is heading up north quite a bit.
If you check the oil...
Brand new 6NZ reman from CAT. If you look at the block there is alot of extra ports and bolt holes. Its actually a SDP block. They...
Looked up a MXS and BXS crankshaft. Both are the same part number. Sdp has a different part number however.
I run the big cam in my versitile off 2 truck batteries. Starts better then the old 4d batts and still runs the lights, seeder, monitors and gps
In sask. Truck had local plates too. Got a good amount of rednecks around here.
General lee was by a month ago for some work. Full flag on top the sleeper[ATTACH]
Get the batteries tested or replaced. One of them is boiling over/ gassing off.
Also be carefull, battery explosions can happen and are...
Truck built 05/14/02
Engine serial number 6nz69127
Engine built 2002/04/26
That data is only good for the one engine. What exactly are you looking for and for what engine number?
That is one groovy setup.
Normal wear. Nothing to worry about.
There is no flasher relay. All is done in the cecu/chassis node. The cecu can be programmed for led lights though.