I have Orbcomm on my one trailer. $18/month. I don't remember it tracking vehicle speed, but it has a lot more than just GPS & temperature.
Could be the bunk fan itself went out. If you find the fuse and it is intact, take a lead (light) tester to the connector for the fan. If all...
On an old trailer I no longer have, I had carriage bolts installed when repairing cracks to get rid some flex on the floor near them. If they are...
I wouldn't think that only an inflame is due, and that instead consider an out-of-frame might be advisable instead., unless maybe you will be...
I've heard the fuse between the batteries and ECM can go bad to where current intermittently can be interrupted. If the truck has redundant backup...
Did anyone check behind the dash? Airleaks at one of those thin airlines can be very quiet. Maybe at a valve, as well.
MLC Adventures has got it right, I think. The cracks in the head, and super high pressure from compression indicate that. I should have thought of...
Oil getting by the gasket? Looks like it got to the coolant galley. Did you take an oil sample? Is there any coolant in the oil?
What does this switch do? I owned an fld for 15 years (until 2015) and don't know that there was a switch-at least I never had one go bad. Is it...
I've had firsthand experience dealing with this issue and figured out that the slightest change in anything that can effect fuel flow rate through...
Undercurrent to the starter solenoid? Bad grounding?
I have little experience dealing with electrical issues. I have to say, though, it reminds me of my problem 10 years ago. The solenoid on the...
I am replying on this subject because I am wanting to generate interest in high end shocks. I know RK is out if business, but I heard Pittsburgh...
I run in direct most of the time. Never had a problem after 700k miles. RTLO16713A tyranny. However, I always thought direct was getting out if...
Price? Warm oil and draw some oil for analysis. Wear metal rate gives a better idea of the condition of the engine. You can "inspect" the bull...
Heat! A cheap propane torch screwed onto a 1lb can of propane might be enough heat.
I've had the supply valve on my trailer go bad once.
The problem in the window regulator? You might be able to find a video on YouTube to see how that all works.
Have an exhaust blowby pressure test done. The more exhaust that gets by between the piston rings and cylinder walls means oil is getting by too....
I misspoke and didn't remember right. I would put a board under the driveshaft at the yoke and lift with a 20 ton bottle jack to free the U-joint...
