That 5EK was built in August 1995. so at some point it was swapped into that 1999. The 5EK is a solid engine, it doesn't have quite as good a...
After turning the powertrain data link to j1939 you will still need to go in to your output selections and change the appropriate outputs to the...
If that code is active that is your culprit for the lights being on. You have a wiring issue to the ABV valve for your steer axle or the valve...
Yes Ideally you get the ECM tuned for no iva and the 16.1 pistons. You can get by without it if you leave the iva housings in and iva's hooked...
That is some luck finding a kit that quick, I have 2 kits from cat waiting on me for a couple C15's I have to do, but any new ones I'm being told...
Dealers have to make sure everything is set properly in the ECM to the engine serial number, and they should do a full warranty report of it. That...
I won't go to deep on this topic but If the ECM is reading a 2WS serial (possibly someone attempting to skirt e-log rules, though in vain.) it is...
Harness in going to be completely different on any 07 or newer truck, all the switches and gauges on that newer style dash are multiplex, thus run...
You may need to have them enabled in the CECU once you get them installed as well, most trucks if it didn't ship from the factory with it it is...
Had a C13 a while back with codes for all 6 injectors, and low power complaint, and had the keep the RPM's up under load. Ended up putting a new...
Clutch switch is right under the lower dash kick panel on the clutch pedal.
70 pin will be direct plug and play, some parameters may need to be changed in the ECM depending on what the engine came out of and it going into...
You are correct, the RTOC is built the same as a 13speed but the air for the shifter is plumbed as a 9, add a 13speed shift knob and re-plumb it...
cant really tell much from that picture, looks like it may be a 15 but would need to see the back side(output shaft side) to be sure, a 15 speed...
Have any pictures of the trans and the air setup that is on it? I may be able to tell from them. If it is a 15 speed you will know once you start...
If what I think I see in the picture is right there is no fixing that gauge as it is a gas filled line that is sealed and runs from the gauge to...
I can't remember exactly how that specific breaker works but I'm thinking it is a thermal breaker, which would mean after it has sufficient time...
Sound like the progressive shift settings (load based speed control / gear down protection) are enabled in the ECM, used for forcing drivers to...
The cold will show the weakness in batteries and starters, as well as cable connections, starter has to work harder and pull more juice from the...
that should be a 135amp breaker, you can check to make sure that it is bad by jumping the 2 terminal on it to see if you get your power back.
