22 Cascadia Utility Light Wiring

Discussion in 'Freightliner Forum' started by Teancum144, Mar 14, 2026.

Page 2 of 2
  1. Apr 8, 2026 #11
    Teancum144

    Teancum144 Bobtail Member

    7
    0
    Mar 14, 2026
    0
    This is great information, thank you. I noticed you highlighted 11F in the second picture and 6E in the last picture. Are these clips available for use or are they being used? I assume 6E is being used by the existing utility light, right? Do I need to just tap into that wire?
     
    Teancum144, Apr 8, 2026
    Teancum144, Apr 8, 2026
    #11
  2. Truckers Report Jobs

    Trucking Jobs in 30 seconds

    Every month 400 people find a job with the help of TruckersReport.

  3. Apr 9, 2026 #12
    RocketyMan

    RocketyMan Medium Load Member

    554
    337
    Jun 5, 2015
    0
    These aren't clips--these are the electrical connectors. And these connectors are spec'd in your truck by the configuration that are existing and currently used as built by the factory.

    Where ever your tap into, I would suggest not hacking up the wiring too much in case you want to undo anything that's been done. In this case, you just need to use the supply wire while the GNDP wire can just go to a good ground stud somewhere.
     
    RocketyMan, Apr 9, 2026
    RocketyMan, Apr 9, 2026
    #12
  • Truckers Report Jobs

    Trucking Jobs in 30 seconds

    Every month 400 people find a job with the help of TruckersReport.

    • Page 2 of 2