Username:

Message:

<p>[QUOTE=&quot;Inderjit, post: 12371680, member: 204344&quot;]If you are using a hole saw to make holes in the dash panel for a gauge remove the drill bit from the hole saw arbour and replace it with a length of 1/4&quot; rod. Drill a 1/4&quot; hole where you want the gauge and finish it with the hole saw. you will get a better finished cut. Leaving the drill in the hole saw arbour as you bore the hole the 1/4&quot; bit make the 1/4&quot; hole bigger and the hole saw &quot;wanders&quot; a bit making a rough hole.[/QUOTE]</p><p><br /></p>

Your username or email address:

Do you already have an account?

• No, create an account now.
• Yes, my password is:
• Forgot your password?