I have researched on this forum to try to find a starting point.5 yrs ago, the driver said the cruise stopped working when TA replaced the in dash valve(yellow and red ).I have started checking everything to playing with the brake pedal to replacing the transmission speed sensor.The only thing I havnt done is checking the continuity on the clutch pedal switch.The air switches under the dash seems right.Anymore dieas for me to check?The cruise switch light is on as usual.Any ideas on trouble shooting?Where is the grown wire?
Cruise not working on 2000 century
Discussion in 'Heavy Duty Diesel Truck Mechanics Forum' started by henboy1, Sep 24, 2017.
-
-
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
-
I would check the brake and clutch pedal switch.
Take the dash apart and check the area around the brake valves, a wire could've been disconnected. -
I had a 2000 Freightliner that was doing the same thing (2X)
Does your high idle work....?
do your Jakes work as they should...? -
Yes, my high idle and jakes work as they should.What fixed your problem?
-
-
Last edited: Sep 24, 2017
-
-
Also check the "clutch" safety switch
The 2X on my truck it was pIns on the plug going into the ecm
1 pin was for the clutch safety switch (the ecm though I had my foot on the clutch)
2nd time was the pin that told the ecm I had my foot on the brake..Last edited: Sep 24, 2017
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.