Maxxforce barring tool? Want to do an Overhead on it.

Discussion in 'International Forum' started by WMGUY, Oct 13, 2021.

  1. WMGUY

    WMGUY Road Train Member

    1,667
    785
    Jan 1, 2011
    Nine Mile Falls, WA
    0
    I'm looking for a part number or recommendation for a barring tool or way to turn the engine over for running the overhead. I'm probably over thinking it but wanted to check.

    Thanks
     
  2. Truckers Report Jobs

    Trucking Jobs in 30 seconds

    Every month 400 people find a job with the help of TruckersReport.

  3. Ridgeline

    Ridgeline Road Train Member

    17,943
    76,318
    Dec 18, 2011
    Michigan
    0
    NavistarService: TOOL, ENGINE TURNING

    You can make one if you have a welder, drill press, old socket and a 3/8” plate.

    I have one here somewhere that I got in collection of tools from a fleet I bought. No one could figure what it was for but found the above link
     
  4. Heavyd

    Heavyd Road Train Member

    7,264
    5,469
    Feb 4, 2009
    0
    MF 11 or 13 I just used a socket and long 1/2" ratchet on the bolt for the accessory drive pulley where the fuel pump is. I think it takes a 15 or 18 mill socket. DT series, I just turn from one of the vibration dampener bolts.
     
    Flint1 and WMGUY Thank this.
  5. WMGUY

    WMGUY Road Train Member

    1,667
    785
    Jan 1, 2011
    Nine Mile Falls, WA
    0
    I appreciate the info!
     
  • Truckers Report Jobs

    Trucking Jobs in 30 seconds

    Every month 400 people find a job with the help of TruckersReport.

  • Draft saved Draft deleted