I installed a CB in a 1990 White /GMC..When I key up it makes noise in the FM Radio Speaker..if I leave the FM Radio off the CB works good and does not put noise in the FM Radio Speaker..How can I fix this problem ?
Noise in FM Radio Speaker
Discussion in 'CB Radio Forum' started by Michael 247, Jul 4, 2019.
-
-
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
-
Keep stereo turned off when using CB...There is no fix...and the more power you run, the worse it's going to get...
-
Replace the coax.
-
it's a new coax cable from CB Shop
-
-
First make sure your antenna is properly RF grounded. Do this with a multimeter's Ohm function, with one probe on the antenna coax's outside shield such as where it is in contact with the mounting screw collar that normally is attached to the radio, and the other probe on the vehicle's chassis ground. If the Ohm value is not zero, then try installing a short piece of copper mesh to better ground the antenna to the vehicle.
-
I put a ground wire from antenna bracket bolt to a bolt on cab..the noise I'm hearing is talk back..i can hear what I say through the FM Radio Speaker..i will just leave FM Radio off until I get a CB Shop to check it..Thanks for all the replys
-
it's grounding. I've run KWs without that. the FM isn't grounded
Michael 247 Thanks this.
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.