Username:

Message:

<p>[QUOTE=&quot;DougA, post: 6491426, member: 132220&quot;]Did they check the nose cone bearing?That&#039;s usually why that seal fails.Grab the driveshaft,at the nose and see if you can work it up and down.In neutral,with your wheels chocked.Also,worn splines and yoke,can cause it.A new locking nut should have been installed,too.If the nut comes loose it will cause these problems.Hard to believe a shop wouldn&#039;t check that,but from the crap I read nowadays,anythings possible.And yes,they could have frigged the seal up putting it in,spring popped out,etc.[/QUOTE]</p><p><br /></p>

Your username or email address:

Do you already have an account?

• No, create an account now.
• Yes, my password is:
• Forgot your password?