How to back into tight docks.

Discussion in 'Questions From New Drivers' started by Chinatown, Sep 1, 2020.

  1. Bill51

    Bill51 Road Train Member

    Joined:
    Jul 27, 2015
    Messages:
    1,180
    Thanks Received:
    2,973
    0
    Poor chica.
    As soon as the Susan G. Komen charity sees those pink ribbons, they'll sue her into oblivion.
     
  2. SoulScream84

    SoulScream84 Road Train Member

    Joined:
    Mar 21, 2020
    Messages:
    3,426
    Thanks Received:
    26,057
    0
    I was too busy looking at her dock to notice
     
    Wasted Thyme Thanks this.
  3. MericanMade

    MericanMade Heavy Load Member

    Joined:
    Aug 14, 2019
    Messages:
    776
    Thanks Received:
    1,810
    Location:
    Pensacola, FL
    0
    Here’s a gal who probably isn’t covered in tattoos, who probably doesn’t have fake boobs, who is super cute.

    If I were single and not married to an awesome woman, I would be fantasizing about holding her hand over a coke float at the local ice cream shop.

    Wife walked in and I immediately switched to SuperTrucker Dan. :p

     
    daf105paccar Thanks this.
  4. Moose1958

    Moose1958 Road Train Member

    Joined:
    Dec 17, 2010
    Messages:
    15,170
    Thanks Received:
    33,413
    Location:
    Williesburg, Virignia
    0
  5. Six9GS

    Six9GS Road Train Member

    Joined:
    Dec 3, 2012
    Messages:
    1,473
    Thanks Received:
    3,695
    Location:
    Yuma, AZ
    0
    First thing I find that helps is to scrutinize my route before I get there. I'm a Swifter (refridgerated)`and sent a route to follow. On more than one occasion, had I followed the given route, I'd be stuck with having to blindside it in, but was able to route myself to come in from the other direction and avoid the blindside. Also, in tight areas, much of El Paso comes to mind, I'll find a better route to get in and out than the one given. Once I get somewhere like that, it is common I ask the folks at the place the best way to get out. Local knowledge is always a plus.
    However, when I do have to blindside or perform an otherwise difficult back. I take my time and work it in and NEVER fail to get out and look, often, if I have to get out and look once, I'll probably end up getting out a couple more times. I'm not to proud or lazy. Also, when I do get out and look, I walk completely around my rig so I see how much clearance I have in all directions. I may be focusing mostly on the back of the trailer and trailer axles, but when I got out and looked, and walked completely around the rig, found I was tighter or not as tight as I thought at the front of the trailer and tractor on my blind side. It's important not to miss the clearances there too!
    When I was really new, on several occasions, if other truckers were there, I'd ask one to help spot me. Never had a problem getting that help when I asked. I haven't needed a spotter in awhile, but I still ain't too proud to ask for help if I need it! I figure it this way, if other truckers can get into and out of a place, so can I, I just have to work it.
    I tend to try and keep my rear tandems close to that infamous 40' mark. I've found that keeping the tandem location consistent, along with the fifth wheel location, helps me set up my back easier, as you get used to how far to pull up before I start to cut it to get my trailer tandems where I want before I start my back. When I have to set up with my tandems farther forward or back, I'm not as successful and it creates more of a struggle. I figure in time, as I gain more experience, I will get used to having the tandems farther forward or rearward of the 40' area.
    Anyway, that's my 2 cents about backing in tight spots. Avoid them with better planning when you can, take it easy and get out and look as much as needed. Don't hesitate to ask for help and pay close attention to where your tandems and fifth wheel locations are to help get a better set up before you begin to back.
     
  6. Rocks

    Rocks Road Train Member

    Joined:
    Jan 13, 2008
    Messages:
    14,905
    Thanks Received:
    61,114
    Location:
    Somewhere
    0
    I know this has nothing to do with backing into tight docks... but since folks mentioned the Brazilian tattooed driver Sheila Bellaver here...
    Here is an update on her...
    She has now 3 trucks... all with her name on it... she proudly shows her trucks in this video... it's all in Portuguese...
    One truck is called Pinky (the dark pink one), the other is brand new, called Perola and the other is Blacky (black truck)....
    She drives Perola, her husband drives Blacky and she has another guy driving Pinky.
    She starts the video driving her new truck, going to a location to meet with her two other trucks...
    That woman is an intelligent, successful business person and a real road "warrior".. she has 4 kids, she is in pretty good shape and now she is looking for buying a fourth truck...
    The name of her company is Sheila Transportes... her YouTube channel has 1.84M subscribers...

     
    Last edited: Sep 22, 2020
    daf105paccar Thanks this.
  7. HillbillyDeluxeTruck

    HillbillyDeluxeTruck Road Train Member

    Joined:
    Mar 3, 2013
    Messages:
    5,933
    Thanks Received:
    30,328
    Location:
    San Antone
    0
    1.84M tards watching her youtoob paid for those trucks, lol.
     
  8. SoulScream84

    SoulScream84 Road Train Member

    Joined:
    Mar 21, 2020
    Messages:
    3,426
    Thanks Received:
    26,057
    0
    Amazing what a nice rack and dock accomplish.
     
  9. Rocks

    Rocks Road Train Member

    Joined:
    Jan 13, 2008
    Messages:
    14,905
    Thanks Received:
    61,114
    Location:
    Somewhere
    0
    "tards"...? What is the reason for the insult? You know nothing about her story. I bet you were one of those that clicked on her video just for curiosity... :rolleyes:
     
  10. MericanMade

    MericanMade Heavy Load Member

    Joined:
    Aug 14, 2019
    Messages:
    776
    Thanks Received:
    1,810
    Location:
    Pensacola, FL
    0