Where is everyone #5

Hell.......i judge everyone......its what I do.

 

Too bad TTR canned her already. I thought I had her "Perfect Fit" lol.

Figured going team in a 42" flattop shaker from the early 90's would be right up her alley.? Day 28 of the 1st month though, right when we were about to split the months profit 50/50, my old shaker just might have needed a fresh inframe..

If she was understanding enough to stick around, day 29 of month 2, probably would have needed a new 13 speed, a cutoff, & maybe even some paint..

Glad I screen shot her number early today. Now the saggy twins are all mine!!

 

Help....

 

Yeah but we both point and laugh...

 

Plygem. Vinyl siding in cardboard boxes inside crates. Crates are falling apart. Belly straps are pinched under the top layer, but sliding out. Tightening I think made the crates fall apart faster, not sure. So I loosened the straps, added the 3 2" portable straps around the middle vertical parts because there's nothing structural in the horizontal plane...

 

It's okay, we're used to it. So used to it even, that we point and laugh at ourselves if it gets to be more than a couple days and nobody else will.

 

Lmao thanks for the laugh

 

I’m just north of Peoria, IL. Must be going back for warranty work? Loaded up with some good ol Wisconsin lumber headed to the Iowa line in the morning about an hour away. 40 mile bounce to pick up for Galette, WY. For Thursday morning delivery. Already have a cheap, heavy, ugly, tarped load booked tor a return trip for Saturday delivery in Chicago.

 

Not much you can do with that that you haven’t already done from the looks of it? Looks like you did a good job right from the get go too?

 

First it was less than what I was supposed to get. Strapped accordingly. Then they decided to scavenge the rest so I had to unstrap....move to the belly position on each of the 3 stacks (over the 2 middle struts) then the top layer. Straps over the front and back on the top. All straps must be on top of the struts because there's nothing inside to pull down on....
Now the crates are fuked, I can't get the pipe stakes in on the leaned side....I'm pulling the bottom layer over but I don't think it's going to move much with the stuff on top....
Any suggestions welcome.
Its approximately 1600 lb. Per crate i believe. 30k# total load 18 crates