Kenworth T660 fog light switch location
Discussion in 'Trucks [ Eighteen Wheelers ]' started by mitmaks, Feb 5, 2017.
Page 3 of 4
-
-
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
-
Put my switch in checked for fuse and relay all good my switch lights up, but the tester at the bumper doesn’t light up any help would be appreciated thanks in advance
-
I also am looking to add/ enable factory fogs to the harness tied up in the bumper area. I just wish I had the square holes and brackets to mount said lights
Theres no room or clearance to mount them under or over the dam bumper heh -
I've got the fog lights wired in. The bumper got no fog light switch wired into the dash but I can't find the wiring for the panel outside under the hood.
-
Fog lights are installed wiring is hooked up switches in the dash with the new for switch panel only problem now is where is the wiring harness that goes into the fuse box under the hood? I do have the relay and see where the relay goes but I don't have any wires going to the Box does anybody know where the wiring harness might be tied to strap back to
-
-
-
Here is everything you should need to make the fog lights work on t660, t800, or w900.
1. install fog lights into existing harness near bumper.
2. if you only have 3 switches at upper panel. Buy fog light switch (part# p27-1040-08) and panel for four switches (part# S64-1193-240)
3. after connecting switch, you may need to activate fog light using Paccar ESA. if you dont have nexiq or the software you will need your dealer to activate it.
4. Fog light should work now. if it doesn't work check chassis node fuses near engine and Warn lamp fuse (location - F5) -
-
Watch this -Rolling18 Thanks this.
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
Page 3 of 4