Eaton won’t go into reverse after breaking reverse light switch
Discussion in 'Freightliner Forum' started by Dorego401, Feb 28, 2021.
Page 2 of 2
-
-
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
-
The round rod is the part of trans. that pushes the ele. switch you are trying to get out of the side of trans. from the outside, do not put the ez. out in a drill, put a drill bit in drill and lay a clean rag on on inside of trans. to catch any steel bits, then use the ez. out with a long wrench to get a good bite on the broken off part and screw it out when it starts moving?
-
If that circled rod is part of the transmission,
it should pry back with a long heavy screwdriver.
Try that.
Does it move back - like there is a spring in there, too?
That would mean a captured return spring behind that actuator.
It is captured between the broken off part and the rod.
Have you gotten this out yet, and if not, where are you stuck?
You do know U can take make/model to Dealer and get pictures? -
Is this fixed?
-
rolls canardly and Hammer166 Thank this.
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
Page 2 of 2