Where is everyone #5

It's getting pretty bad again... here states are shutting down their cities at night... imposing curfews... so many hospitals in big cities have no more available beds... feds gave money to governors but the money ended and not much was done... corruption, incompetence... people are not taking this virus seriously... not being responsible, not following proper security guides...

 

The pin itself is held stationary in the end of the axle by two wedge bolts if they are loose you will have movement and can’t tell the difference from loose wedges or worn bushings. Generally king pins wear the same on each side. It’s best to jack up the wheel before trying to tighten them. And like James said the loose wedge bolts will allow the king pin to wallow out the end of the axle. If that has happened they have been loose for a long time.

 

We have the same kind of setup at our shop. Bulk truck comes around and fills up our tank when we need it. Ours runs off the air compressor, they supply the tank, pump, retractable hose, and fill nozzle with programmable meter. Pretty handy setup and way cheaper than buying pails of oil.

 

Fish stick sandwiches.

 

Can I borrow your crank handle for just a minute?

 

Kinda figured there was a monkey in the wood pile.

 

Thank you. Im gonna look into that

 

I’ll deliver your oil to you no sweat

 

Hey bayou boy theres a good tanker outfit up here in western montana... if ur wantin to come up here

Need 2 years exp and all ur endorsements...